Posted at Saturday, October 14th 2017 11:43:18 AM by Carol under Cabinets
Installing cabinets whether in a kitchen, laundry or utility cabinets in a garage, they all have the same basic set of installation requirements. Some simple tools are required and are in most handyman`s tool pails. Pencils, good carpenters four foot level, tape measure, screw gun, several Quick type C clamps and a chalk line is a great start. If you have the use of a tripod with a builders level (or can rent one for a day) this will speed the work along greatly. Starting at either end of the cabinet set, make a pencil mark four feet above the floor. Now using the four foot level, transfer that mark along the wall to the other end of the cabinet run and make another pencil mark. Measure down to the floor to see if it is four feet above the floor. If it is exactly four feet, then your floor is level. If it is more than four feet then you know the floor slopes down towards that end. If you start the cabinets at that low end you will not be able to keep the cabinets level before you run "into " the floor. If you start at the four foot end that you started with, you will be able to shim the cabinets up so they all remain the same level height above the floor.
If your cabinets have whats called a four inch high toe kick feature, you may have the option of cutting this four inch height down to offset a small difference in the floor heights. Be careful as cutting too much can make the cabinets look squat. If the cabinets came with a detached set of toe kicks already framed, this makes leveling a great deal easier as well. Just lay out the base cabinet supports and check to see if they are level. Some shimming or minor cutting to provide perfectly sub-base`s makes the base cabinet installation a snap. You need not worry whether each cabinet is level as the bases will automatically make it so.
Once the sub-bases for the lower cabinets are set, I recommend that you install the upper cabinets next as it is just plain easier. Once the wider base cabinets are installed it is harder to work on the narrower upper cabinets. Just measure up from the sub-base to get the top of the cabinets, add the counter thickness, add the space you want between the lower and upper cabinets (typically eighteen inches) and make a pencil mark. That is the bottom of your upper cabinets. Since your sub-base is level, just transfer the upper cabinet mark all along the run and you will have mark to set the bottom of each upper cabinet. Next locate all the wall studs and make a vertical mark using your level that will protrude both above and below the cabinets.
If you are working alone, take a piece of one by two inch furring and screw it to the wall flush with the bottom of the upper cabinet mark. You will be able to rest the cabinet on the furring while you plumb the cabinet and fasten it to the wall. Starting with the first cabinet, go ahead and screw the cabinet securely to the studs using three inch drywall screws. You can countersink them or course or use screw washers depending on what you want the final appearance to be.